Skip to main content

Questions tagged [ahb]

8 votes
3 answers
818 views

I'm trying to figure out if on-chip busses (for e.g., ARM AMBA) have dedicated metal paths for each direction between the components the bus connects. Or does the bus use the same metal path to make ...
agshe's user avatar
  • 95
2 votes
0 answers
108 views

This sentence comes from AMBA AHB Protocol Specification(IHI 0033C) page 3-30. https://developer.arm.com/documentation/ihi0033/c/?lang=en For my understand, if the AHB manager launch a write operation ...
benjstark's user avatar
0 votes
1 answer
409 views

I'm trying to monitor the HRDATA and HWDATA on the AHB-Lite bus transfer. The monitor message should only appear when a command(...
Carter's user avatar
  • 673
0 votes
1 answer
170 views

I recently overcame an issue while writing some startup assembly for the STM32G474, which had to do with each peripheral having a "clock enable" bit that needs enabled before the peripheral ...
Aaron Linnell's user avatar
1 vote
2 answers
277 views

I've been working with a project regarding an SRAM Controller in Verilog. As you can see, my controller should include those blocks. I've written some Verilog Code and right now I'm trying to test it, ...
Giuseppe Trematerra's user avatar
0 votes
1 answer
1k views

Here is a timing diagram showing a basic write transfer: The HWDATA comes 1 clk cycle after the control signals and the address. Why is this so? What will happen if the HWDATA is put on the bus at the ...
gyuunyuu's user avatar
  • 2,347
0 votes
1 answer
962 views

I have a question regarding the data during the BUSY state in a AHB bus. Consider the following example of an AHB master writing data onto an AHB slave: ...
x7ktrz's user avatar
  • 23
2 votes
1 answer
347 views

How does the Cortex M0+ processor use the AHB-Lite interface to fetch instructions and data? Are instruction fetches done always using NONSEQ? How does it fetch data from memory (using burst or NONSEQ ...
Vignesh Dhamotharan's user avatar
1 vote
0 answers
201 views

Is it legal for open source cores to be compatible with the AMBA specification?
user avatar
-1 votes
1 answer
790 views

Producer has confirmed that if there will be concurrent AHB and APB2 transfers using DMA2, then data corruption will occur (source). The bug discovery is from 2012, many years ago. Is the STM32F4 ...
Gortu's user avatar
  • 11